Hi all I'm after a 2.0ltr injection pinto head an I need a 4branch manifold for the same engine can any 1 help?
Cheers matty

I have this if it's any good to you. I think it came off a Tiger.

[img]http://
Tiger ? exhaust [/img]

Sounds silly but what's the length of pipe from where it bolts to the head to the first bend
Cheers matty

Not silly, but you'll have to wait until tomorrow when I'll measure.

What about a 2.0 EFI complete engine ?
It's a 205 block with alternator.

Any good

Macbest that will b great thanks
As for the efi engine how much are u asking an where abouts are u

U2u sent

barkalar,
your abit far from me and that's a bit pricey also for me thank you anyway

Sorry for the delay.

Flange face to start of first bend is approx 31cm.

I have an injection head with a piper cam and an rs2000 4 branch manifold but it's bolted to a 2.1 pinto that has been sat in the garden covered up for the last 3 years and also there's a complete gasket kit to go with it,I do have a full spec on the engine if interested,it was running before being removed for a project that I had but never got to fitting it no sensible offer refused

U2u sent

Replied

Replied

Replied

Replied