Board logo

Zetec Valve Stem Oil Seal Removal
the_big_1 - 8/8/20 at 01:10 PM

hi guys,

What do you use / tips, to remove valve stem oil seals on a 2.0l silver top Zetec?


big_wasa - 8/8/20 at 03:10 PM

I pulled a set out a Blacktop yesterday. I used a pair of valve stem pliers made by laser.

I had to grind a bit of so I could get them deeper

[Edited on 8/8/20 by big_wasa]

[Edited on 8/8/20 by big_wasa]

the_big_1 - 8/8/20 at 03:25 PM

Where did you grind off, the handle bit?
Did they come out easy with the tool?

Many thanks!!!

big_wasa - 8/8/20 at 03:58 PM

I canít upload photos again.

But if you imagine needle nose pliers tapering and getting thicker. You need to take a little of the tapper to get them in deeper.

Very easy, took all 16 out in seconds. Grip and wiggle.

the_big_1 - 8/8/20 at 04:35 PM


Will order some and give it a go!

Top man as usual!!!

snippy - 9/8/20 at 03:52 PM

I also bought these when overhauling my zetec to replace the valve seals. They work a treat. Didn`t have to grind anything off mine though.