To fit twin 45s to my avaon which inlet manifold do I need. The straight one or the angled up one?

Cheers
Mike

I would think straight for weber/dellorto, these need to be horizontal for the float chambers, the angles ones (upward) tend to be for bike carbs to throttle bodies.

This assumes your engine is upright and not canted over at an angle.

have a measure first, make sure nothing is going to hit the top chassis rail

I didn't mean an angled manifold, I was more meaning the one that steps up. I think I need the straight one. Anyone got any good recommendations as to where to get one?

Cheers
Mike

What engine are you using?

Zetec blacktop