Board logo

Where to get exhaust tip
pekwah1 - 20/5/20 at 08:37 PM

Hi guys,

Have been searching for ages for a 2” 90 degree bend and outwardly rolled but can’t find one.
Anyone got any ideas?

Thanks
Andy


big_wasa - 20/5/20 at 09:19 PM

I couldn’t find one sensibly priced either and stainless is hard to form so I welded one on with a straight slash cut.


ianhurley20 - 21/5/20 at 08:27 AM

I made my first one but later came across custom chrome from Nuneaton at the national kitcar show. They will make anything. They made me a 2" stainless tailpipe with a 90deg bend and rolled edge to my exact measurements and were not expensive (£14 inc post??). You can find them on facebook or https://www.cherrybomb.co.uk/ and I think other sites as well


pekwah1 - 21/5/20 at 09:23 AM

Thanks both, will definitely try the custom chrome guys!


Leeroy06 - 21/5/20 at 07:11 PM

I had the same problem. I had a 80 degree bend kicking around and ordered a 6mm thick mooring ring on ebay. Welded it on the tip of the pipe then fettled it back with a belt sander. Has come out spot on. The mooring ring was less than £2.