Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Cylinder head gas flowing
lewis

posted on 13/11/19 at 09:17 PM Reply With Quote
Cylinder head gas flowing

I have a ST 170 head that I want to get gas flowed (polished & ported) can anyone recommend a company to carry this out? I’m in West Sussex.





I am a driving god!..........sort of

View User's Profile View All Posts By User U2U Member
ttalps2000

posted on 14/11/19 at 08:04 AM Reply With Quote
Dunnell Engines?
View User's Profile View All Posts By User U2U Member
Schrodinger

posted on 14/11/19 at 08:20 AM Reply With Quote
you could also try Scholar Engines http://www.scholarengines.co.uk/

both Scholar and Dunnell are in/near Stowmarket Suffolk.





Keith
Aviemore

View User's Profile E-Mail User View All Posts By User U2U Member
pigeondave

posted on 14/11/19 at 01:46 PM Reply With Quote
Have a look round the Ditchling area (could be the industrial estate)
I'm sure that there was someone local.

Other wise I'd say Dunnell, but its a trek.

Is there no-one in Guildford area?

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
rusty nuts

posted on 14/11/19 at 01:54 PM Reply With Quote
Vulcan engineering , just off the M20 specialise in Ford engine and heads
View User's Profile View All Posts By User U2U Member
procomp

posted on 14/11/19 at 01:55 PM Reply With Quote
Having just had an ST170 engine in for quick check over that had received head work by a company listed above, Id simply say just deal with CNC heads.
couldn't fault there work on a customers engine i rebuilt last month.

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
Dick

posted on 14/11/19 at 03:07 PM Reply With Quote
Neil Roper you wont get better and hes not as expensive as you may think. Lot oh engine builders use his heads
View User's Profile View All Posts By User U2U Member
obfripper

posted on 14/11/19 at 08:28 PM Reply With Quote
Get hold of A.L Developments, he did a good job on my zetec head, it was 2-3 weeks turnaround, he also fitted a set of valve guides and ported/matched the inlet to the head at a very reasonable rate.

Have a look at his work here:
https://www.facebook.com/AL-Developments-846552508744383/
If you're not on facebook, i can pm his email address.

Dave

View User's Profile View All Posts By User U2U Member
lewis

posted on 15/11/19 at 01:18 PM Reply With Quote
Thanks all, I will make some calls





I am a driving god!..........sort of

View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.