Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Xflow bolts
joneh

posted on 23/1/19 at 08:35 AM Reply With Quote
Xflow bolts

Morning,

Rebuilding a xflow, do people reuse the mains cap and head bolts? Guessing best practice is to buy new but as they're not stretch and in good condition I figure they'd be ok.

I will replace the rod bolts with the Burton heavy duty replacements as it's only a 1300.

Thanks!
Jon

View User's Profile View All Posts By User U2U Member
snapper

posted on 23/1/19 at 09:15 AM Reply With Quote
If it’s a 1300 and not highly tuned or revs above the standard red line, I would consider using the old bolts having carefully checked them for any damage.

Rod bolts are always worth replacing and I only use ARP as you can use them again and again





I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)

View User's Profile View All Posts By User U2U Member
redturner
Senior Builder






Posts 449
Registered 9/11/12
Member Is Offline

Photo Archive Go!
Building: Run 2 ltr Black Top in single seater race car.

posted on 23/1/19 at 06:01 PM Reply With Quote
Re-use the head and main cap bolts, fit new big end cap bolts....
View User's Profile E-Mail User View All Posts By User U2U Member
steve m

posted on 23/1/19 at 07:47 PM Reply With Quote
As above ^^

Ive always reused the head bolts and mains bolts, on all my xflows, and probably a lot more than I should
But I do like to keep a record of what ive done to either engine, and the conrod bolts have been replaced on both engines





Thats was probably spelt wrong, or had some grammer, that the "grammer police have to have a moan at




View User's Profile View All Posts By User U2U Member
joneh

posted on 23/1/19 at 09:20 PM Reply With Quote
Cool, Thanks that saves a few quid.

Jon

View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.