Mash
|
| posted on 6/3/17 at 07:03 PM |
|
|
zx9r pinto manifold
So, having tried to find a second hand one to no avail, and loving the DanST ones but finding them outside my budget,
I have embarked upon making my own. Assembled the bits:
[img]
 
Manifold parts
[/img]
DanST flange £37.99
Tube courtesy of a Mate up north who is a rep for a tube company £0.00
Flouro lined silicon hose, Ebay £16.55
S/S jubilee clips, Ebay £6.95
So just over 60 quid. A bit cheaper than the kits, but mainly due to the high quality DansT flange.
time to get the welding kit out methinks
|
|
|
|
|
Mash
|
| posted on 8/3/17 at 10:28 AM |
|
|
Have a question folks
I'm presuming that the carbs should be angled to get them to the same angle that they were on the bike, so....
Do I just try and gauge it from where the float bowl looks about right?
Sorry if this is a silly question, and thanks in advance...
|
|
|
