furryeggs
|
| posted on 4/8/17 at 11:50 AM |
|
|
Well thats a little annoying...Stack tacho
I've had what I thought was an issue with my Stack ST200 Tacho's wiring. As soon as the ignition is on the back lights been permanently
lit. As there are only 3 wire's +12v, 0v and ECU tacho driver there isn't a separate feed for the light.
I've emailed Stack to question the back light being on and they have said that's correct. The ST200 tacho has/is a permanently lit
gauge.
I now have to drive around with 1 gauge permanently lit or my side lights on all the time to light the other gauges. Ok it's not a major issue
but it is a little annoying, maybe I'm a bit OCD.
|
|
|
|
|
joneh
|
| posted on 4/8/17 at 12:49 PM |
|
|
Nope - that would annoy me too!
|
|
|
loggyboy
|
| posted on 4/8/17 at 12:57 PM |
|
|
dismantle/reassembly possible?
Mistral Motorsport
|
|
|
pekwah1
|
| posted on 4/8/17 at 01:08 PM |
|
|
I hate to say it, but that should have been obvious if only 3 wires.... how would it know your lights are on otherwise?
But yes that would irritate the hell out of me too!
|
|
|
djaques
|
| posted on 4/8/17 at 10:41 PM |
|
|
You could try 213 Performance in Bicester, they may be able to modify the gauge. They were able to repair my Elise Stack dash when no one else would
touch it.
|
|
|
Angel Acevedo
|
| posted on 5/8/17 at 04:52 AM |
|
|
Simple solution may be install a dimming pot?
Beware of what you wish.. for it may come true....
|
|
|
Phil_1471
|
| posted on 5/8/17 at 06:11 AM |
|
|
Connect the others up so they are permanently lit too...?
You can live in a car but can't rally a house
|
|
|
