hi guys,

i need a 1.8 zetec flywheel for a 2l conversion in my locost.

i called the salvage yard but they dont have 1.8 engines, they do howevere have a large heap of flywheels...

is there anything specific about the 1.8 zetec flywheel or numbers cast into it so i can recognize the thing ?

[Edited on 3/2/17 by Gre3D]

i have one and a cct133 thrust bearing £80 for both if your interested plus postage

Numbers depend on all sorts of things, year, factory, engine spec etc etc...

However they all look the same, like this...

thx coozer! any pics of the rear face?

Just measured the thickness on an 1800 silvertop engine i have for sale if anybody is interested and it's 35mm near the ring gear if that helps.

thank you mike, could you perhaps post a picture of the rear face of the flywheel?
if i can't seem to find a flywheel at the scrapyard then you guys are my best option i think

Here you go, good luck!

thanks! you guys have been most helpfull,

while we're at it, any idea how many degree before TDC the missing tooth is?

I have one if you want. £29 collected from KT9 1JN, or £45 posted.

quote:

---

Originally posted by Gre3D
thanks! you guys have been most helpfull,

while we're at it, any idea how many degree before TDC the missing tooth is?

---

Thx coozer. Remind me to buy you a couple of beers should i ever meet you 😃

i manages to find a flywheel in the scrapyard, there was only one though.
the face of the flywheel needed some machining because it was f*cked up. probably been driving with a worn clutch and burning the whole thing. but it's looking fresh as ever at the moment