goaty
|
| posted on 2/9/09 at 07:06 PM |
|
|
Shinny bits
After a few weeksn wait they are finally here.
1mm oversize low comp forged pistons
steel H section rods
arp bolts to match with all the gubins.....
Now just alot more bits to buy 
[img] [/img]
[img] [/img]
[img] [/img]
|
|
|
|
|
JEPY
|
| posted on 2/9/09 at 07:19 PM |
|
|
MMmmmmmm, shiny bits
What are they going into? looks serious given the dished and pocketed pistons!
|
|
|
flak monkey
|
| posted on 2/9/09 at 07:30 PM |
|
|
Duratec, supercharged by the sounds of it
How much boost are you thinking of running. Bear in mind you can run about 0.9bar with std compression ratio 
Sera
http://www.motosera.com
|
|
|
goaty
|
| posted on 2/9/09 at 08:11 PM |
|
|
not to sure yet, will run a little boost at first then up it as i go along, aiming for 300bhp and torque to match.
It will be a longish build as i am doing everything this time round apart from the head. Only a mild port and polish with some cams and see what
happens.
I dont think i will be disapointed.
Got a dry sump kit to pick up this week and now on the look for a charger.
|
|
|
l0rd
|
| posted on 2/9/09 at 08:48 PM |
|
|
Loads of nice and expensive ashtrays
Just kidding
|
|
|
goaty
|
| posted on 2/9/09 at 08:49 PM |
|
|
lol, old ones will shortly be used as trays
|
|
|
