Board logo

Side panel cutouts
jps - 23/1/17 at 07:29 AM

I've sketched out a card template for the holes I need to cut in my side panel. I had intended to try to keep as much material as possible but do I just chop out the whole bit that i've shaded in the picture below?

Description
Description


CosKev3 - 23/1/17 at 07:47 AM

I would guess that piece will snap off anyway if it's not got anything supporting it from behind? (Assuming it's GRP not alloy )


mcerd1 - 23/1/17 at 08:32 AM

If you can put a decent radius in the corners (ie. drill it first, then cut it in between) then you'd have a bit more holding on to the shaded bit
then it'll probably ok as long as its fixed something behind it


big-vee-twin - 23/1/17 at 01:49 PM

[img] First Wishbone
First Wishbone
[/img]