Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Type 9 Reverse Switch Connector
mikeb

posted on 26/5/17 at 03:25 PM Reply With Quote
Type 9 Reverse Switch Connector

I'm onto almost the last wiring job, the reverse light. I don't have the two pin connector for the type 9 reverse switch. Any one any ideas where to get one or recommend something that will work?

Thanks

Mike

[Edited on 26/5/17 by mikeb]

View User's Profile View All Posts By User U2U Member
rash12
Contributor






Posts 355
Registered 22/7/11
Member Is Offline

Photo Archive Go!
Building: built sr2 ,hillman imp 1.8 under development

posted on 26/5/17 at 04:26 PM Reply With Quote
pricy but there are some on ebay 201928617651
Seller assumes all responsibility for this listing.

[Edited on 26/5/17 by rash12]

View User's Profile View All Posts By User U2U Member
rusty nuts

posted on 26/5/17 at 04:38 PM Reply With Quote
Would a connector from a Focus or Ka fit? Should be easy to find one of those.
View User's Profile View All Posts By User U2U Member
stripe

posted on 26/5/17 at 05:01 PM Reply With Quote
the female bullet crimp connectors just fit over the pins
View User's Profile View All Posts By User U2U Member
big-vee-twin

posted on 26/5/17 at 11:03 PM Reply With Quote
I soldered two wires onto the switch covered each with heat shrink insulation then used crimp bullet connectors





Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016

http://www.triangleltd.com

View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [ 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.