r1 plumbing again 4XV
At the moment the plumbing is a big mess so I am fitting new polo rad hoses & tank ..I have looked and read lots off posts for the best way of doing this so I think I am ok.At the moment I have a small pipe from the thermostat to a inlet at the end of the carbs next to the plug not sure what to do with this as most post say the small thermostat inlet/outlet should be plumbed in to the header tank pipe. If so where's
small pipe from the carbs go. car was running BL mini rad and no header tank.

[Edited on 23/3/12 by 0hooters0]

[Edited on 23/3/12 by 0hooters0]

[Edited on 23/3/12 by 0hooters0]

do you have a pic of the pipe on the carbs?

on my 4xv there was a small pipe coming out just below the inlet ports on the heads, tapping into the jackets.

No photo of end of pipe but you can see the pipe run .photo in archive thanks.

Hi
This is the water layout on our R1 5JJ Indy.
Works fine. ( see our photo archive)
René

Thanks all done now all new plumbing and gearbox mot and taxed today detling show on Saturday