Does anybody know where I can get a new wiring plug for the oil pressure switch used on the Duratec? One came with my engine, but the wire was cut off flush.

Connector looks something like this -


Description

New no.

You could lift the yellow bit and remove the pin, carefully open up the crimp and add a new wire. solder and rebuild.

It looks like same plug as the blacktop onwards zetec plug.

Just had a look in the garage and I have spares so if you cant get a new one, send me a self addressed jiffy bag and I will send you one.

Thanks for the offer - will see how I get on - found these - http://www.simtekuk.co.uk/product.php/1_way_sealed_sensor_connector_b_cfp/?k=:::5830476

And these in the US annoyingly - only $1.81 !!!!!! http://www.corsa-technic.com/category.php?category_id=103

Yep, but I guess postage wont be as cheap and easy.

Postage is pretty cheap according to their website.

Anyway been doing some more research, looks like a lot of these connectors are Tyco/AMP units in the SSC range. Some good info here - http://www.te.com/commerce/DocumentDelivery/DDEController?Action=showdoc&DocId=Specification+Or+Standard%7F114-8004%7FG%7Fpdf%7FEnglish%7FENG _SS_114-8004_G.pdf%7F184042-1

Oil Pressure switch is a Tyco/AMP unit, SSC Model, Part no - 184042-1

You can buy from Mouser UK or order Free samples from TE Connectivity

Cam/Crank sensors are also the same series and you can get them the same way