Board logo

4A-GE Conversion Kit for Phoenix / Fury (engine mounts, exhaust manifold, clutch, propshaft, flywheel, bellhousing, transmission
reb - 4/6/17 at 09:44 AM


I am converting to a bike engine an hence I am selling the stated below parts which will enable you to install a Toyota 4A-GE engine and a Ford Type-e 4 speed transmission into your Phoenix or Fury.

These parts were installed in a Phoenix so they will probably fit a fury as well but I can not guarantee this.

If the gearbox is overkill for your needs, you can buy the kit without it!

- Engine mounts for 4A-GE engine (you will need to weld two simple steel plates on your frame to be able to mount these, see pictures)
- Exhaust manifold "4 into 1 race" design, very well made, no cracks
- Propshaft (will sit perfectly between a 4 speed type-e transmission and a Sierra diff)
- Lightweight flywheel (stock 4A-GE one, but machined extensively)
- Clutch (special clutch from, clutch cover will suit 4A-GE flywheel, clutch plate will match Ford type-e spline, 7mm thick.)
- 4A-GE transmission bellhousing to Ford Type-e transmission

- Ford Type-E 4-Speed Rocket transmission with straight cut Tran-X Synchro Gears, Ratios are: 2.54 - 1.66 - 1.255 - 1, BHP Rating 230-240 (approx.)

The transmission is in a good shape and all gears are engaging very smoothly and it doesnt make any strange sounds.

However it is leaking slightly between the bellhousing and the transmission, hence a brand new and large set of gaskets is included.

This is pretty much a complete kit, the only part which you require is a clutch release bearing which you can get from burtonpower.

Total price (including shipping): GBP 1500.00

All parts including bellhousing but without transmission (including shipping): GBP 700.00

[Edited on 4/6/17 by reb]

[Edited on 4/6/17 by reb]

[Edited on 4/6/17 by reb]

[Edited on 4/6/17 by reb]

reb - 13/6/17 at 09:12 AM

Update: The installed tran-x gears are 2.48 - 1.69 - 1.28 - 1, very close to the stock rocket gear ratios which are 2.54 - 1.66 - 1.255 - 1

Here the pictures again as the ones from the first post seem to be down:

upload pic

[Edited on 13/6/17 by reb]

ian.stewart - 13/6/17 at 06:38 PM

U2U sent

ttalps2000 - 26/6/17 at 10:57 AM

willing to sell the manifold seperatly? ?

1960dave - 15/7/17 at 03:56 PM

Did you ever sell this?

reb - 15/2/18 at 04:20 PM

Still available!

reb - 13/3/18 at 12:40 PM

Just the exhaust manifold and the engine mounts left now.

1960dave - 13/3/18 at 12:47 PM

How much for the engine mounts?

reb - 17/4/18 at 07:43 AM

Originally posted by 1960dave
How much for the engine mounts?

I prefer to sell both the mounts and the exhaust manifold together, if someone buys the exhaust manifold and does not want the mounts I can sell them separately.

1960dave - 17/4/18 at 08:32 AM

How much?