Quaife straight cut, synchro gearset and ford motorsport viscous limited slip diff, to suit FWD BC gearbox - will need to be built up into a gearbox - I can do this for an additional cost - £1,500.
SBD air filter with aluminium back plate to suit SBD Duratec throttle bodies - never fitted as it won't fit on my car - cost £154 new - £100 delivered.
Exhaust silencer, stainless, 6" body, 2-1/4" pipe, 14" long, comes with the two clamps - I cut the body down to size as it was slightly longer - Probably £20 but would need to get an idea on postage.
2-1/4" coil springs, 450lb/in, 7" long - £15 posted
Silvertop Zetec coil pack, can send the HT leads for spares if required - £15 each posted
Fiesta ST 150 Duratec sump - Probably £25 posted but will need to get a better idea on postage
Wilwood Pull Type Slave Cylinder for converting clutch to hydraulic - £50 posted
Fiesta ST150 Duratec flywheel - Probably £40 posted but will need to get a better idea on postage
Malpassi Petrol King Regulator For Carburettors - £40 posted
Dan ST Duratec stainless steel exhaust flange with 1-7/8" port holes - never used - £35 delivered
https://danstengineering.co.uk/index.php?route=product/product&product_id=188&search=duratec
Sierra drive hubs / Rear Axle Outer Stub - think this is 100mm / 86mm PCD - £20 posted
Westfield rev counter, 80mm - does not have the light holder in the rear for illuminating - £30
VDO temperature gauge, 52mm - does not have the light holder in the rear for illuminating - £20
Durite oil pressure gauge, 52mm - does not have the light holder in the rear for illuminating - £20
Ford Fiesta ST150, Duratec, gearbox - £200
Spare wheel carrier for Brian James Minno trailer - £30 delivered
1 x rear support stand for Brian James Minno trailer - £15 delivered
All items located in Aberdeen in Scotland.
[Edited on 4/11/17 by cosmicicecreamman]
[Edited on 4/11/17 by cosmicicecreamman]
[Edited on 5/11/17 by cosmicicecreamman]