Board logo

Aero Catch part
killerferret666 - 19/3/17 at 04:54 PM

Has anyone managed to be able to source a replacement rubber piece that goes over the main bolt. Its quite a tough rubber with a little give.

Basically when mine was originally fitted its been cut 1mm or 2mm too short and just means the bodywork can move slightly and rattles....annoys the hell out of me!

MsD - 19/3/17 at 05:35 PM

Not sure about getting replacements, but mines fitted with a length of rubber coolant hose cut to length!
Mark.

tims31 - 19/3/17 at 05:52 PM

quote:
Originally posted by MsD
Not sure about getting replacements, but mines fitted with a length of rubber coolant hose cut to length!
Mark.


^^^That's what I would do too...

Kev99 - 19/3/17 at 06:19 PM

also can u not just put a washer under the rubber sleeve to make it longer

killerferret666 - 20/3/17 at 09:42 AM

quote:
Originally posted by Kev99
also can u not just put a washer under the rubber sleeve to make it longer


Potential to rattle. I cant take that risk

Schrodinger - 20/3/17 at 12:06 PM

quote:
Originally posted by killerferret666
quote:
Originally posted by Kev99
also can u not just put a washer under the rubber sleeve to make it longer


Potential to rattle. I cant take that risk



Rubber washer?

ken555 - 20/3/17 at 12:32 PM

quote:
Originally posted by killerferret666
quote:
Originally posted by Kev99
also can u not just put a washer under the rubber sleeve to make it longer


Potential to rattle. I cant take that risk


Tap washers ?

killerferret666 - 20/3/17 at 08:01 PM

Good ideas, i may get a few rubber washers to play about with so I can get the ideal height then cut it from hose, rather then chopping constantly till I get the height right and wasting alot of hose!