does anyone know what could cause the clunking ticking rattle noise you can hear in the video?
https://youtu.be/Dt_GpJwW9B0
I first thought it was the clutch so I've fully stripped it down, apart from slightly worn plates i can't see anything obvious that would
cause it, and when i turn the input shaft to spin the gears i can't hear the noise. I'm at bit of a lose and don't really want to strip
the engine down much further if it can be helped.
[Edited on 4/10/15 by Spud1985]
Maybe clutch release bearing if you very lightly put your foot on the clutch pedal does it go?
just listened back to the full video and its hard to tell if the noise goes or not.
However i have just ordered a couple of bearings for the clutch (Part No: 93310338S6 & 93310228S5)
I assume this is a new noise. Always find it hard to diagnose noises from videos but...
It sounds more like it's in the prop/diff/shafts. BEC? Double check the prop' adapter, the prop bolts (both ends and shaft bolts (if
lobro's).
Do you get the noise in other gears? Does it go if you push the clutch in?
quote:
Originally posted by adithorp
I assume this is a new noise. Always find it hard to diagnose noises from videos but...
It sounds more like it's in the prop/diff/shafts. BEC? Double check the prop' adapter, the prop bolts (both ends and shaft bolts (if lobro's).
Do you get the noise in other gears? Does it go if you push the clutch in?
New friction plates, steels and bearings has somehow resolved the issue.
No obvious signs of what it could have been and the engine is now rattle free and the quietest it's been.
Completely baffled me but glad it's sorted ready for a PH run at the weekend.