Board logo

Radiator in a zetec cat e1
Matt159888 - 20/2/17 at 04:58 PM

Hi guys after a few pics if anyone has and spec for a radiator for the zetec fitment in a tiger e1. I have decided to go zetec and have stripped the old pinto ready to come out and am collecting bits for the zetec. I want to start first with the radiator setup. I think I need the 1.0 polo radiator am I right.? And does anyone have any pics of the fitment in a tiger ? Thanks again matt


femster87 - 20/2/17 at 05:18 PM

Rebuild
Rebuild


In my old Tiger R6. Radiator is available for sale


Matt159888 - 20/2/17 at 05:48 PM

Very nice not sure that would fit in the e1 nose cone though. Seems very high?. My nose cone only has half inch clearance so the rad has to sit lower I think?


snippy - 20/2/17 at 09:00 PM

The Ali VW Polo rad will fit. I have done this conversion on my Zetec Cat E1 a few years ago. If you pm me with your email I'll dig out my pics for you. You will need to reroute the water pipes as on the Polo rad the upper and lower water outlets are both on the same side (nearside).


Matt159888 - 20/2/17 at 10:12 PM

Thanks buddy will send it now