Shorty
|
| posted on 10/4/14 at 05:31 PM |
|
|
zetec manifold to cat plate
Does anyone know where I can get a steel mating face plate to bolt direct to the zetec blacktop standard manifold?
As the standard cat is way too big, I was going to custom make a cat section that will bolt direct to the standard exhaust manifold.
I'm sure I've seen them somewhere but can't find anything.
If not I will have to measure up and have one cut out of 5mm or so steel plate.
Thanks
|
|
|
|
|
wombat
|
| posted on 10/4/14 at 05:57 PM |
|
|
U2u sent
|
|
|
Shorty
|
| posted on 10/4/14 at 06:32 PM |
|
|
I suppose I could cut the top off the original cat I have but would seem a waste of a perfectly good cat
|
|
|
