jps
|
| posted on 19/1/17 at 09:39 AM |
|
|
Making GRP floppy?
I've seen mention somewhere that leaving GRP bodywork out in the sun can help make it a bit more pliable to help with fitting. Will I get the
same effect bringing the panels inside to a hot room (30c) for a few hours?
|
|
|
|
|
Moorron
|
| posted on 19/1/17 at 08:57 PM |
|
|
I doubt it, I found only high temps worked for me.
With my black bonnet in the sun around summer time it would make it more pliable, it was almost too hot to touch. not at 30c
If its very thin you might get some help from a fan heater.
Sorry about my spelling, im an engineer and only work in numbers.
|
|
|
