focijohn
|
| posted on 8/10/08 at 05:59 PM |
|
|
405 Heater Matrix
Anyone on here ever done one of these out of a late L plated car, and:
1) Kept their language to an acceptable level
2ndly) Kept their mental status "sane"
I failed in both of the above, does anyone have any tips if i have to put it back together on Friday hopefully someone will do the hard bits for me
when I'm at college tomorrow .
Cheers
John
Anyone going slower than you is an idiot. Anyone going faster than you is a maniac.
Too many targets but too few bullets.
|
|
|
|
|
NigeEss
|
| posted on 8/10/08 at 06:58 PM |
|
|
Answers :
1 No
2 No
Complete ba@@$%d aren't they.
Manuals say dash has to come out but you can get away with releasing
it and pulling away from bulkhead enough to work behind.
Did one years ago and never, ever again
|
|
|
rusty nuts
|
| posted on 8/10/08 at 07:17 PM |
|
|
You think a 405 is bad ? Try a late Renault Espace! they have 2
|
|
|
minordelay
|
| posted on 8/10/08 at 08:20 PM |
|
|
Did one through the glovebox once, abit of bracket cutting would help out!!!
|
|
|
focijohn
|
| posted on 8/10/08 at 09:13 PM |
|
|
took me 3 hours, ended up air chiseling the welds on the support that runs around the dash bending it down and cutting the glove box support! Drilling
holes in the dash to get the screws out ffs finally came through the dash. Best of all i consulted the book of lies and it said remove glove box undo
5 screws and withdraw hahahaha what a crock. It never fails to amaze me how much easier they could make it but don't......
As i said ^^ look forward to putting it in
[Edited on 8/10/08 by focijohn]
Anyone going slower than you is an idiot. Anyone going faster than you is a maniac.
Too many targets but too few bullets.
|
|
|
.jpg)
