To be honest, I'm stumped. How can i mount a trigger wheel to my Ali bottom pulley? The main problem is that the bolt is recessed.

Any answers/soloutions would be gratefully recieved.

ATB Dan.


[img][/img]

Make a spacer on the lathe and get a longer bolt?

David

is there room to bolt it behind the pulley ??? just done the same for a mate on his v8 engine, machined out the trigger wheel and bolted through the back

best regards
marc

See Link Oh and if you havnt got one yet? I have a new one with sensor that I decided not to use

I would turn a register on the wheel to fit into the pulley centre bore and then with it located drill and tap six 3 or 4 mm holes through the wheel into the pulley and secure it with cap screws.
Paul.

Outstanding gentleman, knew i could rely on you.

Aother cheeky question, does anyone know that the threads are for the front pulley bolt and timing gear cover on a crossflow?

ATB Dan.