82 Locost
|
| posted on 25/5/12 at 08:00 PM |
|
|
Help me identify this diff please
I was told this is an English diff, but it doesn't look like my other diffs (the centre bit is enclosed and it's heavier).
Cheers
|
|
|
|
|
HowardB
|
| posted on 25/5/12 at 08:17 PM |
|
|
have you checked the ratio?
Howard
Fisher Fury was 2000 Zetec - now a 1600 (it Lives again  and goes zoom)
|
|
|
82 Locost
|
| posted on 25/5/12 at 08:37 PM |
|
|
4.1 is written on it in tipp-ex, which would point to a standard English ratio, but I've never seen one with a bulky lump in the middle.
I'm more used to something like this:
|
|
|
adithorp
|
| posted on 25/5/12 at 08:55 PM |
|
|
LSD?
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
|
HowardB
|
| posted on 25/5/12 at 09:08 PM |
|
|
quote:
Originally posted by adithorp
LSD?
I've never seen inside one that is LSD, so can't comment
Howard
Fisher Fury was 2000 Zetec - now a 1600 (it Lives again and goes zoom)
|
|
|
snapper
|
| posted on 26/5/12 at 05:32 AM |
|
|
The way to tell if it's an LSD is to put the half shafts on and turn one if they both move the same way it's an lsd
I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)
|
|
|
minitici
|
| posted on 26/5/12 at 07:50 AM |
|
|
That is definitely an LSD.
You can see the plates and the split line at the cross-pins in the first photo.
|
|
|
82 Locost
|
| posted on 26/5/12 at 08:53 AM |
|
|
Thanks guys, I'll do the driveshaft check.
|
|
|
MikeRJ
|
| posted on 26/5/12 at 10:18 AM |
|
|
I wouldn't bother, it's 100% definitely an LSD.
[Edited on 26/5/12 by MikeRJ]
|
|
|
82 Locost
|
| posted on 26/5/12 at 03:08 PM |
|
|
That's amazing. I didn't even know I had it.
[Edited on 26/5/12 by 82 Locost]
|
|
|
82 Locost
|
| posted on 26/5/12 at 04:19 PM |
|
|
Right. I've just been for another look and it's definately an LSD. However, it's not an English Diff as it's larger but it is
a 4.11. It also takes 25 spline half shaft (not 22 spline English). The flange has 8 holes, which appears to allow a small or large prop-shaft flange
to fit.
The numbers:
Crown wheel 72VB 4210-aa 9-37
Casing 81VB 4025-AB (I think, it's quite corroded)
Any ideas?
|
|
|
82 Locost
|
| posted on 26/5/12 at 07:55 PM |
|
|
Apparently it's a Transit diff.
|
|
|
