Ady, tried ringing yesterday but no answer, could do with you looking at this roll bar im making for you mate, there may be a problem where your harness mounts need to fit, give us a bell.

Joe



Ady roll bar

[Edited on 23/4/10 by welderman]

[Edited on 23/4/10 by welderman]

When Lovespoon meets ROPS!

ETA: If I didn't know better I'd say that this post was the best piece of viral marketing I've seen for a while!

[Edited on 23/4/10 by TimC]

quote:

---

Originally posted by TimC
Lovespoon

---

quote:

---

Originally posted by NigeEss

quote:

---

Originally posted by TimC
Lovespoon

---

My first thought too !

Nice bit of work though

---

Have you enough clearance above to be able to get the bolts into the harness mounts?
Excellent bit of engineering that.

quote:

---

Originally posted by mistergrumpy
Have you enough clearance above to be able to get the bolts into the harness mounts?
Excellent bit of engineering that.

---

That looks good, Joe. I've not been able to get on-line all day, otherwise I'd have got back to you sooner.

I can't remember the height I put on the drawings for the cross bar. I'll measure the min' height it can be (from the boot floor to the holes in the seats) tommorow. I'd prefer to put the bolts down hill but I can't see any reason why they can't go upward, so it is a possibility.

adrian

any news !