My alloys rather suffered in my recent run-in with another car, Mojo has been treated to a new set!

Personally I think they are beyond economic refurbishment, but would make a fine set of build wheels, with the added advantage that 2 of the tyres were only replaced last September so have most of their original tread remaining, so could be re-used further down the line.

Tyres are 195/50/15 Toyo T1R which I've found good for my 'everyday use' with occasional trackdays.

Wheels are Inovit Rapid 15x6.5 ET38 Multistud fit (4x100 and 4x108) which weigh ~6.5Kg without tyres. Includes 3 spigot rings for Ford hubs (4th one broke up on removal so has been binned).

Wheels themselves are a mixed bag; in order from worst to best (pics of damage below):

No1 has significant scoring to the spokes & machined edge + >80% worn T1R

No2 has surface marks to the spokes and some scoring to the machined edge, missing centre cap + >80% worn T1R

No3 has a short section of damage to the machined edge + <10% worn T1R

No4 is undamaged + <10% worn T1R

pics on this post:
https://jpsc.org.uk/forum/viewtopic.php?f=6&p=10671#p10671

£75 collected from Warwick (Tyres cost me ~£90 last Sept)


[Edited on 27/6/15 by nre]

[Edited on 27/6/15 by nre]