Board logo

SG7s meet 2nd October - Herts
Xtreme Kermit - 29/9/11 at 08:10 PM

Hi All. The SG7s are meeting this Sunday the 2nd of October from 11:30 to 14:00.

George and Dragon
19 High St, Graveley, Hitchin -
SG4 7LE

http://www.georgeanddragongraveley.com/

The weather forecast is looking good, which will make a change after the last couple of meetings where we have had to take shelter...

Come along and say Hi!

Ian


scudderfish - 29/9/11 at 08:38 PM

I've just got my fuel tank back in so I might make it

When did the venue change?


Xtreme Kermit - 29/9/11 at 08:47 PM

About April / May. We found the old one shut for a renovation one month when we turned up, so we decamped a couple of miles down the road. The owners of the new place seem nice, any they do nice food without having to have a whole carvery meal.

Hope to see you there, even more hopefully I'll be in Kermit so long as the new master cylinder arrives tomorrow and I can get it fitted in time!


Xtreme Kermit - 30/9/11 at 06:26 PM

Bump


scudderfish - 30/9/11 at 06:36 PM

What size master cylinder do you need? I've got one kicking around the garage which might do.


MakeEverything - 30/9/11 at 07:12 PM

I was hoping to have the beast ready for sunday, but its going to have to be next month as long as the weather stays good for me to get the work done on it.

Not much to do....


Xtreme Kermit - 30/9/11 at 08:19 PM

Thanks scud, it's a 22.2 Lucas steel body job.

It's a bit frustrating because I've just put new seals in the body, and now the reservoir must have cracked in some way, because it dumped the whole lot overnight


scudderfish - 30/9/11 at 09:05 PM

Ah mine is a 3/4" job (19mm) for a remote reservoir

Give my local factors (Milehams) a bell on 01582 765678, they've also got a place in Dunstable as well.


Xtreme Kermit - 1/10/11 at 11:07 AM

It looks like the MC I ordered was not in stock as originally stated and hence the delay. Hopefully it will be herevMon/Tue... Hopefully.


rusty nuts - 2/10/11 at 08:57 AM

Suns out so I may pop along.If you see this Andy I will be bringing the steering link


Andybarbet - 2/10/11 at 10:24 AM

Cheers Mel,

I wont have time to stop but i will be passing so will see you there - Cheers