Can anyone suggest someone/somewhere to look at my 160A mig? The cooling fan has stopped running (it seems to weld just fine), so I expect that the ability to weld on the higher power settings is restricted...

Does anyone know of anywhere that services MIGs? Preferably in the Southampton area, but I am prepared to travel if needed!

This place gave good advise when I was looking to buy...

http://www.migtigarc.co.uk/

When mine went I just ripped out the old fan and bolted a couple of these to the side casing wired to the on/off switch.

240v fans

Afterwards the welder was a little more noisy but could weld at full power all day far better than the original effort.

I expect you can get some for pennies on eBay, not worth paying someone to even look fixing what is there.

Regards Mark

Mug tig and arc as already stated.... They are a great help.....

Dave B