tomgregory2000
|
| posted on 14/3/09 at 06:30 PM |
|
|
VDO Speedo problems HELP
One of the fail points on my SVA was my speedo.
It didnt go past 35mph, ok i thought that should be easy to fix, Oh how wrong was i.
In kinda fixing the lack of speed (it now go's upwards of 80mph) but i now have a new problem 
The needle on the VDO vision speedo now flickers all over the place, if it starts off at 60mph it flicks between 50-70mph.
So i thought there must be some interference somewhere so i have run new wires between the sensor and gauge and a seperate power supply and it is
still playing up
Is there aything i have missed?
I bought them from westfield back in May 2005 so i guess it is out of warranty.
All help needed
Tommy
|
|
|
|
|
IDONTBELEIVEIT
|
| posted on 14/3/09 at 06:38 PM |
|
|
what tyre size are you running,and what is your pulse value,is it running from a hall pick up and where from
i'm running the same set up from westfield
cheers wayne
[Edited on 14/3/09 by IDONTBELEIVEIT]
Are We There Yet, Are We There Yet!!!!
|
|
|
tomgregory2000
|
| posted on 14/3/09 at 06:48 PM |
|
|
i cant remember what the sensor is called but it ony has the 2 spade terminal on it and picks up on a metal object.
I have a speed ring fitted on the n/s drive shaft and the sensor looking at it, it has 6 tabs but they are only about an 3/4" wide, is this to
small an area for the sensor to pick up on at speed? i would have thought that would have been enough metal to look at
|
|
|
martthefridgeman
|
| posted on 14/3/09 at 07:16 PM |
|
|
I had a similar problem with my racetech speedo and it was due to a too large an air gap/ inconsistent gaps between the sensor and the teeth on my
drive shaft. also is your sensor solidly mounted so it does not pick up any vibration. other than that is the cable to the sensor screened and
grounded at one end. ATB Martin.
|
|
|
blakep82
|
| posted on 14/3/09 at 08:48 PM |
|
|
i would think more the sensor than the speedo too actually
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
Agriv8
|
| posted on 14/3/09 at 09:10 PM |
|
|
I had all sorts of problems very similar to the ones you are experiencing
started using one of these on the recomendation of MNR bought it from ETb instruments ( using 2 magnets of the prop ) and all is well
regards
Agriv8
[Edited on 14/3/09 by Agriv8]
Taller than your average Guy !
Management is like a tree of monkeys. - Those at the top look down and see a tree full of smiling faces. BUT Those at the bottom look up and see a
tree full of a*seholes .............
|
|
|
IDONTBELEIVEIT
|
| posted on 15/3/09 at 08:41 AM |
|
|
i've set mine up with an air gap of about 2mm inline with the socket heads on my drive shaft lobros,how big an air gap have you got,no more than
5mm,are all your tabs dead inline
cheers wayne
Are We There Yet, Are We There Yet!!!!
|
|
|
