Printable Version | Subscribe | Add to Favourites
<<  1    2  >>
New Topic New Reply
Author: Subject: Iva booked,pics uploaded..any advice please?
doobrychat

posted on 30/4/13 at 09:53 PM Reply With Quote
Iva booked,pics uploaded..any advice please?

Hi all..

once read a post about lots of eyes looking over people's work..
so thought this was a good place with lots of experienced eyes looking over my MK before its IVA test..

See my album...

all comments welcome..

thanks in advance..

View User's Profile Visit User's Homepage View All Posts By User U2U Member
ragindave

posted on 30/4/13 at 10:05 PM Reply With Quote
Nice looking car and a great colour scheme
View User's Profile View All Posts By User U2U Member
doobrychat

posted on 30/4/13 at 10:07 PM Reply With Quote
Thanks..
View User's Profile Visit User's Homepage View All Posts By User U2U Member
loggyboy

posted on 30/4/13 at 10:08 PM Reply With Quote
Wheel arches look a little too angled back, you need 30 degrees forward from vertical. Might be the camera angle but worth checking.

Side repeaters on skuttle will likely fail on 5 degree viewing angle from rear as rear arches will obscure them.

You will need a rear view mirror in the centre.

Is the rear fog absolutely vertical, it needs to be.

Front indicators need to be min 400 from widest part of car so will need extension arms.

Worth reading the manual again!

[Edited on 30-4-13 by loggyboy]





Mistral Motorsport

View User's Profile View All Posts By User U2U Member
theduck

posted on 30/4/13 at 10:11 PM Reply With Quote
From cycle wings don't look to come forward enough. Also although hard to see in those pics do your front inductors cone out wide enough?
View User's Profile View All Posts By User U2U Member
adithorp

posted on 30/4/13 at 10:11 PM Reply With Quote
Looks nice.

Few things worth checking..
Check the requirements for the position of the front arches. Think they have to extend far enough forward to be ahead of the formost rim when viewed from above. I could be wrong as that doesn't apply to my car.

Your side repeaters will fail the angles of visability test as the rear wings will obscure them. Fitting on either the front or rear arches seems to be the way to go. Do a search to see what others have done.

Are your harnesses sloping up from the rear mounts to the holes in the seats? If so they'll fail as it makes the seat "structural". Extending the illars they mount on so they're level or sloping down will cure (even though it'll be poor engineering and temprary)

Are all your required labels on? Brake fluid, balance bar, manufacturers plate (check required info as some have failed for not enough or too much)...





"A witty saying proves nothing" Voltaire

http://jpsc.org.uk/forum/

View User's Profile View All Posts By User U2U Member
doobrychat

posted on 30/4/13 at 10:12 PM Reply With Quote
ok thanks..

keep em coming boys, if it doesn't fail the test i'll lay the first £90 down at the bar of a big meet up this year..

View User's Profile Visit User's Homepage View All Posts By User U2U Member
doobrychat

posted on 30/4/13 at 10:18 PM Reply With Quote
i will adjust my front arches tomorrow but i have seen a few with similar repeaters in the same place pass the iva..

the front indicators are spaced above minimum distance apart as per iva manual..

many thanks for the comments.. I am making a 'to do' list as we speak..

View User's Profile Visit User's Homepage View All Posts By User U2U Member
loggyboy

posted on 30/4/13 at 10:23 PM Reply With Quote
quote:
Originally posted by doobrychat
i will adjust my front arches tomorrow but i have seen a few with similar repeaters in the same place pass the iva..

the front indicators are spaced above minimum distance apart as per iva manual..

many thanks for the comments.. I am making a 'to do' list as we speak..


They may have passed SVA but IVA changed a few things and im pretty sure you will fail on those side repeaters.

Front indicators may have sufficient space between the but they must also be 400mm max from edge, yours are closer to 500mm.





Mistral Motorsport

View User's Profile View All Posts By User U2U Member
Charlie_Zetec

posted on 30/4/13 at 10:25 PM Reply With Quote
*POST HIJACK ALERT*

For your rear fog and reverse lights, what plinths are you using to make them vertical?!?
Aside from that, looks cracking!





Artificial intelligence is no match for natural stupidity!

View User's Profile View All Posts By User U2U Member
doobrychat

posted on 30/4/13 at 10:30 PM Reply With Quote
the same as the others but machined to angle them so they are vertical..

going to look at the seatbelt thing tomorrow.. they currently angle up but do they have to line up with the seat holes? its only mm lower?

thanks for your assistance guys..

View User's Profile Visit User's Homepage View All Posts By User U2U Member
Acc8braman

posted on 1/5/13 at 05:51 AM Reply With Quote
quote:
Originally posted by loggyboy

You will need a rear view mirror in the centre.


[Edited on 30-4-13 by loggyboy]


You sure about this one, I not have one in mine?

View User's Profile View All Posts By User U2U Member
loggyboy

posted on 1/5/13 at 06:21 AM Reply With Quote
quote:
Originally posted by Acc8braman
You sure about this one, I not have one in mine?


2. An interior mirror must be fitted, (see note 3)
3. The vehicle must have an nearside exterior mirror fitted (if the interior rear view mirror gives no view to the rear or the rear window is less than 70% light transmittance) (see note 3 & 5)

Note 3: The interior mirror must be positioned as far as is practical to afford the best possible view to the rear, if the interior rear-view mirror does not provide any rearward vision its presence shall not be required.






Mistral Motorsport

View User's Profile View All Posts By User U2U Member
renetom

posted on 1/5/13 at 06:29 AM Reply With Quote
Hi
Great looking car , well done
Just a few observations.
Exposed locknuts on trackrods

Central rear view mirror IVA compatible

Side indicators will fail , ours did.
We were told by Mr IVA man to put them
in the rear arches (see borrowed pict)
Description
Description

indicators
indicators


Front indicators need extensions

have you got one of these



good luck
René

View User's Profile E-Mail User View All Posts By User U2U Member
Acc8braman

posted on 1/5/13 at 06:37 AM Reply With Quote
quote:
Originally posted by loggyboy
quote:
Originally posted by Acc8braman
You sure about this one, I not have one in mine?


2. An interior mirror must be fitted, (see note 3)
3. The vehicle must have an nearside exterior mirror fitted (if the interior rear view mirror gives no view to the rear or the rear window is less than 70% light transmittance) (see note 3 & 5)

Note 3: The interior mirror must be positioned as far as is practical to afford the best possible view to the rear, if the interior rear-view mirror does not provide any rearward vision its presence shall not be required.



Thanks, think I will take these details with me when I do mine

View User's Profile View All Posts By User U2U Member
Barkalarr
Contributor






Posts 942
Registered 14/3/12
Location Essex
Member Is Offline

Photo Archive Go!
Building: Caterham R300, Caterham Roadsport,Indy R1,Indy Zet

posted on 1/5/13 at 06:40 AM Reply With Quote
Things we can't see are the emissions, noise, brake bias, reverse

Have you got these sorted?

View User's Profile View All Posts By User U2U Member
adithorp

posted on 1/5/13 at 08:07 AM Reply With Quote
quote:
Originally posted by doobrychat
going to look at the seatbelt thing tomorrow.. they currently angle up but do they have to line up with the seat holes? its only mm lower?
..


They checked my belts with a spirit-level. They had to not touch the bottom edge of the holes when the belt was horizontal.





"A witty saying proves nothing" Voltaire

http://jpsc.org.uk/forum/

View User's Profile View All Posts By User U2U Member
doobrychat

posted on 1/5/13 at 12:03 PM Reply With Quote
i have moved arches round a bit and look fine with the angles in the IVA bible..

seatbelts are now level with the seat holes..

going to pop into VOSA and have a chat as its only 2 minutes away about the indicators..

Noise wise its well quite for what i expected it to be and there is no visable emsissions but going to test that this evening..

rear view interior mirror fitted.

reverse works fine and light works when the button is pressed..

thanks to Rene for the pics and info on replacement side repeaters

View User's Profile Visit User's Homepage View All Posts By User U2U Member
40inches

posted on 1/5/13 at 12:13 PM Reply With Quote
When is the test booked for? Don't leave sorting the emissions till the last minute, if the engine is post 1995 it will
have a CAT test.






View User's Profile View All Posts By User U2U Member
doobrychat

posted on 1/5/13 at 12:41 PM Reply With Quote
the engine is 2002 gsxr 1000 fully rebuilt by Iane racing it has a cat in the exhaust so will find out more later..

I have only paid for my test this week so i expect within the next four weeks although i did select the asap box..

does anyone know about the seatbelt extensions for where the bolt mounts to the top bar of the chassis.. has anyone had an issue with an inspector over the height?

many thanks Lads..

View User's Profile Visit User's Homepage View All Posts By User U2U Member
loggyboy

posted on 1/5/13 at 12:45 PM Reply With Quote
Which VOSA station are you near?





Mistral Motorsport

View User's Profile View All Posts By User U2U Member
doobrychat

posted on 1/5/13 at 12:48 PM Reply With Quote
Gillingham.. had a few MSVA there and V.I.C checks there over the years and freindly bunch of chaps.. happy to share info so far..
View User's Profile Visit User's Homepage View All Posts By User U2U Member
Bizarro

posted on 1/5/13 at 03:13 PM Reply With Quote
Whats the radius like on the bottom edge of side and rear panels?

I had to stick 'tadpole' type edging onto the bottom edge of mine for IVA

View User's Profile E-Mail User View All Posts By User U2U Member
doobrychat

posted on 1/5/13 at 10:58 PM Reply With Quote
I really want to fit a diff diffuser but been advised not too so abs sheet will go on for now to keep it tidy underneath..
View User's Profile Visit User's Homepage View All Posts By User U2U Member
doobrychat

posted on 16/5/13 at 09:53 AM Reply With Quote
Just popped round to Vosa to get my test date.. booked in for the 30th of may...

Caterham was there so had a chat and look round...They don't put anything round the lower edge and it has a similar 90 degree bend on the lower edge as mine does but i believe they have a different test to amateur builders as its a vehicle produced in small volume.. Hence why their front indicators don't sit within 40cm of the outside edge etc..

More worrying was the inspector looking over my bike parked as its got more bolt on goodies than Crescent can supply but its got an M.O.T so NERR in your face Mr inspector!!!

Well excited now and thanks to all those that had their say on my pics as i have done all the mods recommended by these posts...

View User's Profile Visit User's Homepage View All Posts By User U2U Member
<<  1    2  >>
New Topic New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.