NS Dev
|
posted on 4/9/06 at 11:42 AM |
|
|
It lives!!!
Finished the wiring loom off and finally fired up the 7 yesterday!!!
Not a single fault in the loom, which was a surprise as a couple of evenings I was a bit the worse for wear whilst soldering parts of it up!!!
lol!!
Engine fired up straight away, couple of followers were VERY steady to pump up so think they might need changing, but otherwise great!
Forgot just how bloody loud throttle bodies with no air filter on are!!!! Never mind the exhaust for SVA, it'll fail on induction noise, the
clatter is deafening!!!
Think its about time to get SVA booked!
eeek
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|
|
omega 24 v6
|
posted on 4/9/06 at 11:53 AM |
|
|
Where's the link so we can see/hear it.
|
|
NS Dev
|
posted on 4/9/06 at 11:58 AM |
|
|
where's a good site for free vid hosting?
I'll try and post one! (I'm not techy enough for these modern times!!)
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|
Crazy Jay
|
posted on 4/9/06 at 12:17 PM |
|
|
Email the clip to me and i'll stick it on youtube if you want
ferrarijames@hotmail.com
[Edited on 4/9/06 by Crazy Jay]
|
|
MikeR
|
posted on 4/9/06 at 12:55 PM |
|
|
I'll sort it out when you pop round this week....
didn't sound that loud or impressive when i got the phone call - seem to recall describing it like a fiat uno engine....
|
|
NS Dev
|
posted on 4/9/06 at 02:48 PM |
|
|
....................says the cheeky bugger with a crossflow!!!
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|