Does anyone know which thread the hose-nipple has on the rear caliper from Golf IV?

I plan to use a pair of these goodies on my new dedion setup.

[Edited on 12/4/09 by Micael]

do you mean the brake fluid inlet?

i don't know the answer, but its most likely to be M10

If the rusty old brain is working I vaguely recall it being 10X1.0.

I measure the hole and it is somewhere round 10,6 mm. Which make it larger than M10x1

quote:

---

Originally posted by Micael
I measure the hole and it is somewhere round 10,6 mm. Which make it larger than M10x1

---

yupp, I'm sure. I can drop an M10x1 nipple in the hole.

After some snooping on the net i have found that it might be m12x1.

I will take a picture tomorrow

the thread is m10 by 1.25. 100%

The Golf calipers I have are also bigger than M10.

So looks like there's more than one varient...

Mine is 12x1 mm with banjo-fitting.


Rescued attachment Picture_002__Large_.jpg