hi guys been tinkering all day and was wondering whilel sorting thro my engine stuff what clutch parts im going to need to link the type9 to the zetec 1800 any1 got any clues?

Assuming its a 1.8 flywheel...

Mk1 Mondeo 1.6/1.8 clutch plate and cover, Capri Ct133 release bearing.

Job done!

I used a 2.0 mondeo clutch in mine with a ct 133 release bearing. No problems so far

if its a 1.6-1.8 fly then an early mondeo clutch but you must check it has a 220mm Od 23 spline 1" centre on the clutch plate.

With the above bearing and a spigot bearing.

quote:

---

Originally posted by deltron63
I used a 2.0 mondeo clutch in mine with a ct 133 release bearing. No problems so far

---

1.8

quote:

---

Originally posted by deltron63
1.8

---

2.0 should have been the 240mm fly, even the 130 spec 1.8 had the 240mm fly and the mtx75 box.

quote:

---

Originally posted by big_wasa
2.0 should have been the 240mm fly, even the 130 spec 1.8 had the 240mm fly and the mtx75 box.

---

thanks for the reply guys so am i getting this right 1.8 fly wich i have the Mondeo cluch etc and the Capri bearing

quote:

---

Originally posted by coozer

quote:

---

Originally posted by deltron63[/i
1.8

---

Hmm, didn't think the 2L job fitted the 1.8, and I chucked two away for that very reason.....

---