steve m
|
| posted on 27/9/13 at 05:15 PM |
|
|
Wireing up a new central heating programmer
My old Randal 4033 has died, so ive bought a centaurplus c27 (as recommended)
But my electrical wiring knowledge is poor
The old randall wiring is here
http://danfoss-randall.co.uk/PCMPDF/4033.pdf
and the new Centaurplus c27 wiring diag is here
http://www.horstmann.co.uk/downloads/ElectronicDocuments/Central-Heating/C21-InstallerGuide.pdf
Any heating/plumbing experts able to advise me, which wires go were from the randall to the c27
as I cant even start to work it out !!!
regards
steve
Thats was probably spelt wrong, or had some grammer, that the "grammer police have to have a moan at
|
|
|
|
|
I predict a Riot
|
| posted on 27/9/13 at 08:37 PM |
|
|
If you give me more details i will tell you how to proceed.
Is your system fully pumped? Or gravity fed on the hot water.
Do you have a three port diverter valve or one or two two port valves?
Regards Adrian
"Honesty is a very expensive gift. Do not expect it from cheap people ". Warren Buffet on Expectation
|
|
|
steve m
|
| posted on 27/9/13 at 09:09 PM |
|
|
Thanks Adrian
U2U sent
Steve
Thats was probably spelt wrong, or had some grammer, that the "grammer police have to have a moan at
|
|
|
