Does anyone have a drawing of a bulkhead panel to take twin standard girling-type master cylinders as seen in the right hand side of the pic below?
Cheers!
Does it not depend whose pedal box you are going to use as there could be a bit of variation in the spacing? Just choose whose box you will use and then contact them to see if they have a drawing of the back panel of the box for you.
quote:
Originally posted by Richard Quinn
Does it not depend whose pedal box you are going to use as there could be a bit of variation in the spacing? Just choose whose box you will use and then contact them to see if they have a drawing of the back panel of the box for you.
If you are at the design stage of the footwell - be careful how much room there is - I have an OBP pedal box, I also have moderate size 8 feet - now - I can drive it ok with my 'slip - ons' , but with either of my two pairs of trainers on, my clutch foot catches the brake pedal ! Most of my big-footed buddies can't drive it!
quote:
Originally posted by stevegough
If you are at the design stage of the footwell - be careful how much room there is - I have an OBP pedal box, I also have moderate size 8 feet - now - I can drive it ok with my 'slip - ons' , but with either of my two pairs of trainers on, my clutch foot catches the brake pedal ! Most of my big-footed buddies can't drive it!
OI! Were did you get that picture of my car?
quote:
Originally posted by Doctor Derek Doctors
OI! Were did you get that picture of my car?
quote:
Originally posted by Richard Quinn
quote:
Originally posted by Doctor Derek Doctors
OI! Were did you get that picture of my car?
You got a Gemini too?
quote:
Originally posted by Doctor Derek Doctors
quote:
Originally posted by Richard Quinn
quote:
Originally posted by Doctor Derek Doctors
OI! Were did you get that picture of my car?
You got a Gemini too?
Nope thats my car.... The Life-Taker
I think Tim will get the joke.