Board logo

Seatbelt nuts
Padstar - 3/2/13 at 11:05 AM

Having a bad morning. About to weld the seatbelt fixing points CP8 onto the chassis. Are they M12 stainless I should be using? Can't find it in the book and its driving me mad. Guessing M12 from the 12mm diameter in the cutting schedule.


daviep - 3/2/13 at 11:09 AM

Seat belt bolts are normally 7/16" unf

Cheers
Davie


Talon Motorsport - 3/2/13 at 11:59 AM

All seat belt bolts are 7/16 unf and remember to remove any plating before you weld it.
You can not weld stainless to mild steel even if it looks like you have it will not hold and remember these are seat belt mounts!


Padstar - 3/2/13 at 12:27 PM

Playing from the nut?


Padstar - 3/2/13 at 12:39 PM

I was led to believe the welding of any of the bolts to the chassis was more to just hold them in place as when u bolt into it the nut is held by the plate and the weld does nothing as the plate is holding the nut between the nut and bolt


loggyboy - 3/2/13 at 02:15 PM

quote:
Originally posted by Talon Motorsport
You can not weld stainless to mild steel even if it looks like you have it will not hold and remember these are seat belt mounts!


Really,
Ive never heard that before, I understand it needs the correct wire/filler choice, but it can be done.

[Edited on 3-2-13 by loggyboy]