Board logo

Shorter threaded inserts?
Slimy38 - 20/8/13 at 08:38 PM

A previous thread has drawn my attention to these;

http://www.mcgillmotorsports.co.uk/index.php?act=viewCat&catId=29

Basically threaded inserts in a whole load of sizes, but they are a bit shorter than the ones suggested for wishbones. Can these be used on Haynes Roadster wishbones in any way?

liam.mccaffrey - 20/8/13 at 08:48 PM

rightly or wrongly i prefer longer ones. I have mine made at 40mm long generally

DIY Si - 21/8/13 at 10:01 AM

IIRC the maximum pull out strength is achieved at only 1.5 x the diameter of the thread, so for a 13mm or 1/2" bolt that's only 20mm. However, from a peace of mind point of view, I prefer longer inserts, said the actress to the Bishop.