Board logo

Pictures of an IRS Chassis
Chris Green - 27/10/04 at 10:33 AM

Hello everyone!

Please could you post some pictures of your IRS chassis? in particular the rear section.

I am in the process of designing my own setup for the rear end, and would like to see some other setups for some ideas.

Thank you,

Chris.

locoboy - 27/10/04 at 10:59 AM

you have U2U

Bob C - 27/10/04 at 11:13 AM

Trawl the photo archives for MK indy makers. Check out mine (Bob C) for an mx5 based system - you'll need to find your local mazda scrappy for the uprights.
Bob

Chris Green - 27/10/04 at 11:20 AM

Cheers Col / Bob,

Col, what rear upright is in your pic 4x4_lsd_and_wishbones?

Cheers,

Chris.

phelpsa - 27/10/04 at 11:30 AM

Look in my archive. I am in the process of building my IRS (ie. today) and I should have some more pictures in there tomorrow.

Adam

Chris Green - 27/10/04 at 11:55 AM

Cheers Adam,

What rear upright is that? Is it self fabricated to suit a Sierra rear hub?

Thanks,

Chris.

locoboy - 27/10/04 at 12:13 PM

Chris, i think that picture is a westfield set up.

chrisf - 27/10/04 at 12:54 PM

Chris:

I just started a very bland website. It does have pics for you to look at. Mine is exactly the same as Bob C but has inboard dampers.

http://home.comcast.net/~chrisfiaccone/

--Chris

mangogrooveworkshop - 27/10/04 at 05:05 PM

quote:
Originally posted by chrisf
Chris:

I just started a very bland website. It does have pics for you to look at. Mine is exactly the same as Bob C but has inboard dampers.

http://home.comcast.net/~chrisfiaccone/

--Chris


You may think your site is bland but you have plenty ideas and information in your pictures.
Good start make sure you finnish it.

I like the cradle doubling up as a brace in the engine bay area.
Pat

[Edited on 27-10-04 by mangogrooveworkshop]

heinlein - 27/10/04 at 05:34 PM

Nice site - looks like your Mona Lisa is enjoying it as much as you. They are going to have a blast when it's done.

Chippy - 7/11/04 at 12:26 AM

I have some pics in my archive that may give you some ideas. The uprights are my own fabrication, think theres a pic of them to. The rear wishbones and support frame are also my own design. Hope this may help. Chippy.

Chris Green - 7/11/04 at 03:24 PM

Thanks Chippy!

If you get chance to take some more photo's of the rear end, I would like to see them.

Cheers,

Chris.

phelpsa - 7/11/04 at 05:35 PM

My uprights and wishbones are Stuart Taylor.

Adam