Board logo

Type 9 box + Zetec measurement needed!
PSpirine - 4/4/15 at 10:02 PM

All,

I'm about to fix some bits on my chassis, and make sure that the engine mount plates are in the correct place (chassis had a Pinto in it previously and I'm cutting the mounts out as I'll be putting in a Zetec).

Can someone tell me what the distance in X axis (along centre line of vehicle) from the Type 9 gearbox mounting to the zetec engine mounts is (to the hole that goes into the chassis plates that accept the rubber mount)

Apologies if vague, I can probably post up a drawing if it'll help!

Thanks


DIY Si - 5/4/15 at 12:28 PM

I doubt you'll get an exact answer unless you're using an off the shelf mount. If you're making them yourself, you can put them where fits best for your chosen design.