Seems to be that time of year!

I have bent the rear top rail and pic bellow is of one of the bends.

Question is without thinking i have bent it towards the weld. It didnt split whilst bending which is when i would have expected it to but seems ok. This isnt going to cause any problems later in the build is it? Do i need to do it again?

[Edited on 14/4/03 by Gremlin]
Rescued attachment Bend Pic.JPG

Should be alright mate. It is only there to support the rear panel, not structural as such.

Cheers, Stu.

If its not split now then as Stu said don't worry about it..