I am about to have some threaded boss's made and the company want a lot of cash for just a few.
But if we have a lot (100+) the cost comes down a fair bit.
e.g price
£6.50 each for 4 off ( 20mmO/D x 35mm long with M12 thread )
He did say they would be "about £1.50 less may be more just depends on what material we wanted and how many" but he would price them up
properly if I was more serious so my Q. is
Would any one want to do a sort of group buy?
If so what size and thread do people want?
What would people want them making from?
May be we could have a Club Stock ?
Any way if you are intressed or have any comments Email me as I can check that at work as well.
jason@shorttrack.co.uk
What I need is an M12 (x 1.75) male hose tail. I don't care what material it's in and I'd pay £6.50 if I have to.
I think to M/c that form solid would be a lot more that £ 6.50
If you got an M12 x1.75 bolt you could drill out the center and weld a 6mm O.D tube in.That would cost less.
Would that be any good?
Yeah - that's the way it's going. It just would have been nice in ali or something.
I don't need any but would hazard a guess 7/16"unf for harness/seatbelt mounts might be a popular size as not everyone has a 7/16" tap
lying around.
Ned.
I am going down to see the the chap later on today about some other parts he is making for me. I will ask him how much he wants for one off in ally if you want?
How long for the 7/16 UNF boss?
I have started a list
so keep them sizes coming
quote:
Originally posted by ned
I don't need any but would hazard a guess 7/16"unf for harness/seatbelt mounts might be a popular size as not everyone has a 7/16" tap lying around.