Hello all, started to make the new dash today and just wonder what the best way to cut the holes for the extra gauges (oil pressure and fuel level) is?

Thanks

Lee

hole saw

Tank cutters work fine on such plastics, not too expensive from B&Q and the likes.

As above, it is really soft stuff to work so even a big hole witha Forstner bit or similar and a few minutes witha half round file will do the job.

Hole saw probably the best way.

But cheapest probably is to chain drill it with a 1-2mm drill bit and use a file.

HTH,
James

Thanks all, used a hole drill bit and got them done today.

Lee