MakeEverything
|
| posted on 15/3/09 at 01:00 PM |
|
|
29mm Bushes and Tubes
Does anyone know where to get a full set of 29mm bushes? These are for my wishbones, trailing arms and panhard rod.
I bought some from a supplier, but theyre 27mm and fit as well as a Mr Muscle does into Jo Brand.
Ive read the onversations about Poly vs metalastic, but i dont want a ride thats too hard. I need these sooner rather than later, so if anyone has
any, i might be able to pick them up this week.
[Edited on 15/3/09 by MakeEverything]
[Edited on 15/3/09 by MakeEverything]
[Edited on 15/3/09 by MakeEverything]
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
|
|
MakeEverything
|
| posted on 15/3/09 at 01:34 PM |
|
|
Actually, ive just measured, and 29mm would be tight, 30 would be a struggle to press them in without stripping or splitting the rubber. So somewhere
between 29 and 29.5mm diameter by 38mm in length.
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
MakeEverything
|
| posted on 3/4/09 at 12:16 PM |
|
|
Ive found a company that sells bushes and are cheaper than certain power brands.
Poly bushes;
SuperPro
www.superpro.eu.com
Tel +44 (0)1823 690281
Fax: +44 (0) 1823 698109
I spoke to a guy called Richard, who was rather helpful. Thanks Richard!
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
