Tiger Cat e1 front suspension

Not logged in [Login - Register]

LocostBuilders » Forum » Chassis » Tiger Cat e1 front suspension

MIG Welders & ARC Welders at MachineMart.co.uk

Printable Version | Subscribe | Add to Favourites

belgian2b

Contributor

Posts 385
Registered 14/2/09
Location Belgium
Member Is Offline

Photo Archive Go!

Building: a garage

posted on 12/2/12 at 01:12 PM

Tiger Cat e1 front suspension

Hello,

i am rebuilding the front suspension of the Cat E1with new poly bushes.

Polybushes are made for a M12 bolt.
On the sierra, front suspension was also fixed with M12.

But , bolts on the car were M10, and the hole in the suspension brackets are 10 mm.
So, are those hole factory made ?
It looks difficult to rebore with alloy panel on the car.

Would it be a problem if i make some new poly bushes inner tubes for M10 bolts?

Any advice is welcome,

Gerardo

designer

Posting Freak

Posts 3424
Registered 16/11/06
Location West Yorkshire
Member Is Offline

Photo Archive Go!

Building:

posted on 12/2/12 at 02:17 PM

Should be OK as long as the length is the same. You could make a sleeve to fit inside the original bush.

LocostBuilders » Forum » Chassis » Tiger Cat e1 front suspension

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.