RebelGT
|
| posted on 12/8/05 at 06:20 PM |
|
|
CAD-ing Pedal Box....
so I'm killing time at work so I decided to CAD out my pedal box today, and try and figure out what I'm trying to achieve here. I already
decided after looking at this model I'm going to mount the hole assembly (master cylinders and all) on a moveable deck so I can adjust the pedal
distance. Any other features I could work into this design?
|
|
|
|
|
Peteff
|
| posted on 12/8/05 at 07:00 PM |
|
|
The middle pedal needs to hinge at the top to push on the master cylinder, unless you are going to mount it backwards.
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
RebelGT
|
| posted on 12/8/05 at 07:09 PM |
|
|
yeah, i'm going to reverse mount all 3 MC's to make it easy.
|
|
|
Dale
|
| posted on 12/8/05 at 07:58 PM |
|
|
Curious on how high your foot plates will be from the chassis floor. (working on that part myself). I was going to go this route myself untill I
desided it was easier to get my wife a booster seat. I was going to use the upper plate in a groove and heavy spring loaded tapered pins to lock in
place at a series of holes in the edge brackets.
Dale
Thanks
Dale
my 14 and11 year old boys 22
and 19 now want to drive but have to be 25 before insurance will allow. Finally on the road
|
|
|
RebelGT
|
| posted on 12/8/05 at 08:16 PM |
|
|
my pedals are roughly 5" inches off of the floor, I have big feet, so its probally best to measure your foot and put that into the cad like I
did, height and width.
|
|
|
Hellfire
|
| posted on 13/8/05 at 10:35 AM |
|
|
How about mounting a brake switch up there (obviously for the brake sender) better than the pressure devices most of us use IMHO. A lot of people tend
to drive very close to the derrere just to get a better look, in which case a simple depress of the brake will ward them off. Obviously the pressure
device would have to be operational to switch by which time he cold be sat in your boot! 
|
|
|
jack trolley
|
| posted on 13/8/05 at 03:02 PM |
|
|
Check the Tilton and AP Racing websites for drawings of their pedal sets.
|
|
|
