Mark H
|
 posted on 3/2/03 at 10:35 AM |
|
|
Query: Brake pipe mounting.
Hi everyone.
Got engine running last night! I'm now at the stage where i need to do the SVA tidy up, and my first issue is one of holding the brake pipes
secure.
My plan is to put a rubber strip on the bottom chassis rail, then tie-grip the pipes onto the strip at regular intervals. This is quicker and easier
than p clips.
Do you think this would pass the SVA?
Thanks in advance,
Mark (getting excited now!)
Mark Harrison and
Q986 KCP back from the dead...
|
|
|
|
|
Metal Hippy™
|
 posted on 3/2/03 at 10:55 AM |
|
|
WOOHOOOO nice one mate.
Oh and I dunno.
Helpful as ever...
President of the Non-conformist Locost Builders Club. E-mail for details...
|
|
|
David Jenkins
|
| posted on 3/2/03 at 11:07 AM |
|
|
I'm not sure I understand what you're proposing.
However, this is one area where it's better to go OTT in your efforts, to convince the tester that they are well and truly fixed, rather than leaving
them 'iffy'.
The same goes for the fuel pipe and wiring loom - firmly fixed and kept apart.
rgds,
David
|
|
|
Mark H
|
| posted on 3/2/03 at 11:49 AM |
|
|
Thanks David,
This sounds like good advice.
Regards,
Mark
Mark Harrison and
Q986 KCP back from the dead...
|
|
|
