cloudy
|
| posted on 31/7/06 at 01:27 PM |
|
|
Ali Floor Panel - Where from?
Anyone know where I can get hold of some suitable ali for putting a floor in?
James
www.warnercars.com
|
|
|
|
|
ned
|
| posted on 31/7/06 at 02:08 PM |
|
|
Any metal stockholder, parkers steel or the like..
Ned.
beware, I've got yellow skin
|
|
|
cloudy
|
| posted on 31/7/06 at 02:37 PM |
|
|
any idea on cost?
James
www.warnercars.com
|
|
|
John Bonnett
|
| posted on 31/7/06 at 03:36 PM |
|
|
For the floor I would suggest that you use NS4 16swg aluminium. This is an alloy and a lot tougher than pure aluminium.
You will probably find a local supplier in your Yellow Pages under Non Ferrous Metal Stockholders.
John
|
|
|
stevec
|
| posted on 31/7/06 at 03:51 PM |
|
|
Maybe try these.
http://www.metalsupermarkets.com/
|
|
|
scoop
|
| posted on 31/7/06 at 04:04 PM |
|
|
Go to the supplier and ask if you can buy a sheet of 1.6mm scrap ali. Got my last sheet for £12 delivered. It only had a couple of dents on the edges
where it had been wrapped too tight. Easy to beat out.
Steve.
|
|
|
andrews_45
|
| posted on 4/8/06 at 07:14 PM |
|
|
where bouts are you, i have a mk floorpan
|
|
|
