JoelP
|
| posted on 12/11/03 at 11:01 AM |
|
|
Couple of questions on rollbars etc...
Hi all, just wondering if you had to have a roll bar for SVA, obviously a good idea but i cant be arsed really. Either that, or can you use suitable
braced square tube? Or anyone know a place that make custom designs cos i want one on each side if i have to.
Also does the main dash need to be padded or just radiused?
thanks in advance...
|
|
|
|
|
Simon
|
| posted on 12/11/03 at 11:21 AM |
|
|
Joel,
I'm also sort of looking at this area at moment.
I emailed Pipecraft, who haven't got back to me (3 weeks), lolocost (who's standard items are cheap) to see if they can bend tube to my
design - no reply, but only a couple of days so far. Will ring later!
Not necessary for SVA AFAIK.
I think Merlin or Europa offer a tube bending sevice, but IIRC quite pricey.
Anyone else?
ATB
Simon
[Edited on 12/11/03 by Simon]
|
|
|
locoboy
|
| posted on 12/11/03 at 11:25 AM |
|
|
Joel,
Not required as far as i know
Have a look at a thread started by me in the interior section called MDF dash, it explaines all the requirements for the solid / padded dash
options.
ATB
Locoboy
|
|
|
Mk-Ninja
|
| posted on 12/11/03 at 11:25 AM |
|
|
Not sure on the roll bar, dont think its compulsary, but regards the dash , You dont need it padded but you will need 19mm on bottom edge and I think
2mm on all edges ie guages etc. There was a thread not long ago on it.
I'm sure I've got one, just don't know where I've put it
|
|
|
Hellfire
|
| posted on 12/11/03 at 10:26 PM |
|
|
Roll Bar...
A few months ago MK were making some twin one's like on the Audi TT. Looked cool!
Maybe worth a call to him...
MK Engineering
|
|
|
