paulc
|
| posted on 28/4/18 at 06:40 PM |
|
|
Chassis VIN location
Hi,
Finally almost ready to get my chassis power coated, justy a few things left to do.
Stamping the VIN being one of them (I already have a VIN from the DVLA). Not too keen on stamping a tube for all the reasons discussed many times
before.
My pedal box is however made from 3mm steel so shouldnt be a problem to stamp.
I was thinking of stamping the VIN vertically up the corner of ther pedal box in the area highlighted.
 
Description
When I make the pedal box cover I'll make sure the VIN isnt covered.
My interpretation if the IVA manual suggests this would be ok, however I thought I'd see what everyone else thought.
Paul
[Edited on 28/4/18 by paulc]
|
|
|
|
|
adithorp
|
| posted on 28/4/18 at 07:06 PM |
|
|
Think that'll be fine.
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
|
big-vee-twin
|
| posted on 28/4/18 at 10:21 PM |
|
|
I engraved mind using a stencil and dremmel.
[img]
 
Chassis number
[/img]
Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016
http://www.triangleltd.com
|
|
|
