Board logo

Wishbone Brackets?
garage19 - 4/4/04 at 07:49 PM

I have got to the point where i am bolting in my rear wishbones and have noticed that the brackets seem to be a little too wide for the bushes and their metal inserts. When i go to torque up the bolts the bracket sides get pulled in quite a bit so that they are no longer parallel. Is this right, or am i missing something?

It could probably be cured with some shims but MK don't mention anything about the need for these. Has any one else had this problem?

Thanks,

Doug.


Hellfire - 5/4/04 at 12:08 AM

We used spacers to keep the brackets as they are, between 1~2mm depending on gap.